Milano Formals 15 Point Quality Check list
Each garment in Milano Formal Line goes through Stringent 15 point quality check. This give each Gown excellent finish and makes your occasion memorable.
- Fabric Store:
In the fabric store fabric is being checked before issuing it to cutting department. In general not all the fabric is checked. Usually 10% of fabrics are checked for good fabric suppliers. For power loom fabric and printed fabric 100% checking is done.
Fabrics are checked in flat table, flat table with light box or on fabric checking machine. 4 point system for fabric inspection is used to measure the quality level of the incoming fabric.
- Trims & Accessory:
Trims quality is also very important for having a quality garment. Trims inspection is done randomly against the given standards, like color matching. But for trims and accessories quantity checking is essential.
- Cutting Room:
It is said that cutting is the heart of production. If cutting is done well then chances of occurring defects in the following processes comes down. In cutting room, check points are – i) marker checking, ii) cut part audit and iii) bundle checking.
- Printing Checking:
Printing is not a compulsory process. If printing is done in fabric form then printing is being checked in fabric store. For knits garment, maximum printing is done in cut panels. So before issuing cuttings to sewing department, each panel is being checked properly. Defects that are found here is print placement, color matching, misprint or print overlapping or shade variation.
- Embroidery checking:
Like printing embroidery also is not a compulsory process. If there is embroidery work in the garment panels then 100% inspection is done before issuing to sewing.
- Sewing Department:
Checkpoints in the sewing departments are as following.
- Inline inspection:
In assembly line generally check pints are kept for the critical operations. In these checkpoints, 100% checking is done for partially stitched garments and defect free pieces are forwarded to the next process. This type of checking is used for high value garment.
- Roaming inspection:
In this case checkers roam around the line and randomly check pieces at each operation.
- Traffic light inspection system:
Very few garment manufacturer use this inspection system. In this system each operator is given a card for measuring their quality performance. Quality checker goes to the operator and do random check for few pieces and according to the inspection result, checker marked red or green on the card following rating criteria.
- End of line inspection or table checking:
A checker checks completely stitched garment at the end of the line. 100% checking is done here,
- Audit of the checked pieces:
Very few manufacturers follow this audit procedure but it is very essential checkpoint to assure that only 100% inspected garment are sent to finishing from sewing department. And all defective pieces are repaired before sending to finishing.
- Finishing Department:
Check points in finishing department consists
- Initial finishing inspection:
checking done prior to pressing of the garment at finishing room is known as initial finishing.
- Final finishing Inspection:
After pressing garments are again checked and passed for tagging and packing.
- Internal final audit:
After garments are packed up to certain quantity, quality control team, do audit of packed garments. This process is carried out to ensure that before handing over shipment to buyer QC
If the completed work is being checked at each process and defective pieces are corrected before handing to the next process than at the end of production there is very little chance to have a defective at final inspection stage.